Prices in currencies other than GBP are for guidance only. The actual rate will be that used by the credit card company at the time of billing.
Min. Shipping :£0.00
VAT (20%): £0.00
Total: £0.00
Prices in currencies other than GBP are for guidance only. The actual rate will be that used by the credit card company at the time of billing.
Min. Shipping :£0.00
VAT (20%): £0.00
Total: £0.00
THE FINLAND HEATER. Connect into water system via 5/8" (16mm) outer diameter copper pipe stubs (with swelling at ends to tighten worm drive clips behind around water hose).
Complete with four...
Classic car heater water valve. Operated by cable, this is a 'pull to close' valve (though 45 degrees) turning the hot water supply down. 15.7mm OD tube connections with swelling to locate worm...
Cable assembly for operating water valve part number FINCOWV. 700mm assembly length. Cable length 630mm. Wire at one end formed to fit hole in water valve (FINCOWV) operating lever. Turn...
Sprung steel clip for holding water valve operating cable in place. For finland heater cable FINCABLE, but suitable for other 5.5 to 6mm operating cables
The Clayton heater was used in 1960's Jaguar saloons as well as cars from Daimler, Alvis, Lea Francis, Armstrong Siddeley, Rover and the Land-Rover S1.
It is also very similar to the Smiths unit...
The Clayton heater was used in 1960's Jaguar saloons as well as cars from Daimler, Alvis, Lea Francis, Armstrong Siddeley, Rover and the Land-Rover S1.
It is also very similar to the Smiths unit...
The Clayton heater was used in 1960's Jaguar saloons and cars from Daimler, Alvis, Lea Francis, Armstrong Siddeley, Rover and the Land-Rover S1.
It is also very similar to the Smiths unit fitted...
Heater element with motor plate. This is a replacement for the Smiths circular heater element with straight pipes and motor plate. Picture shows motor plate side of element. The elements Smiths...
The Xenos Mk2 Cabin Heater 2 Speed Heater - WITH Demisting Outlets. W 251mm x D 196mm x H 115mm
Clayton heater electric fan - single shaft 1/4" diameter. 12 volt fan motor for Clayton Heaters. Three hole fixing, with the mounting plate in the middle of the motor. Can rotate in either...
Classic car heater water valve. Operated by a cable. This is a 'pull to close' the valve and turn the hot water supply down. Manufactured for Clayton type heaters but can be used with other systems.
Classic car heater water valve. Operated by a cable. This is a 'push to close' valve and turn the hot water supply down. Manufactured for Clayton type heaters but can be used with other systems.
1600mm long cable with a loop at either end. The loop fits the water valve, the other end can be modified to suit. Manufactured for Clayton heaters but can be used with other systems.
Heater demist nozzle. Black painted steel,165mm mounting hole centres 1 1/4" inlet OD. 145 x 10mm outlet.
Chrome Demister Escutcheon, L 185mm x W 17mm, fixing holes centre to centre 170mm